Aeration kit EKUVA HP-50D

Package contents:

1. ​HIBLOW HP-50D membrane air blower (24-month warranty) - 1 pc.
2. JAGER TD 63/2050 membrane tubular air diffuser (0.5 m length) - 1 pc.
3. Connector for attaching the hose to the diffuser - 1 pc.
4. Rubber gasket to ensure the connector is airtight - 1 pc.
5. AISI stainless steel clamps 16-25 mm. 2 pcs.
6. The set requires a hose with a 19 mm inner diameter.  The hose is not included in the price of the set. Purchase the required hose length separately.
    

Technical characteristics of the aeration set:

1. Air flow at 1 m depth - 60 l/min
2. Air flow at 1.5 m depth - 46 l/min
3. Air flow at 2 m depth - 30 l/min
4. Air flow at 2.5 m depth - 20 l/min
5. Recommended diffuser submersion depth - 2-2.5 m
6. Maximum diffuser submersion depth - 2.5 m
7. Maximum recommended hose length - 30 m
8. Air blower motor power - approx. 32 W (depending on operating pressure).
9. Noise level - 35 dB
10. Air blower warranty 24 months.
     

Installation and startup of the aeration set:

1. First, a location for the air blower must be selected. We recommend placing the air blower as close to the body of water as possible. This will help avoid greater air flow losses. The air blower can operate outdoors, but it must be protected from direct precipitation and severe frost. Install the air blower in a sealed box (metal, plastic, wooden). The box does not need to be insulated, but openings must be left for air to enter inside. If there is a gazebo, sauna hut, or another building near the body of water, install the air blower there. In either case, ensure a safe and reliable power supply for the air blower.
2. Hose. Use a pressure hose with a 19 mm inner diameter purchased from us or one you already have (do not use a watering hose). We recommend using a hose no longer than 30 m. Put one end of the hose onto the air blower outlet nozzle and carefully tighten it with the included clamp. Take the air diffuser and screw on the included hose fitting. To ensure airtightness, use the included rubber gasket. Put the other end of the hose onto this connector and tighten it with the clamp.
3. Submerging the air diffuser. We recommend submerging the diffuser as deep as possible (just do not exceed the maximum permitted submersion depth). The higher the water column above the diffuser, the better the air bubbles and the oxygen in them dissolve in the water, and the more effectively different water layers are mixed. The JAGER air diffuser is lighter than water. To submerge it, tie synthetic ropes to both ends of the diffuser and weights to the ends of the ropes (recommended weight 0.5 -1 kg). Other methods of submerging the diffuser may also be found, but this one is the simplest and works perfectly. The recommended rope length between the weights and the diffuser is 20-30 cm. Submerge the prepared diffuser with weights in the selected location of your body of water. The weights will lie on the bottom of the body of water, and the diffuser will rise as much as the remaining rope length allows. In this way, while operating, the diffuser will not stir up bottom sediments or make your body of water cloudy.
4. Plug the air blower into the electrical network and the aeration system will start operating. If there is no need to aerate around the clock, purchase a timer and set the operating mode you need. The aeration system is designed to operate in both continuous and intermittent mode. Enjoy using it.
    

More data about the air blower:

More data about the air diffuser: