Aeration set EKUVA HP-60

Equipment:

1. ​Membrane air pump HIBLOW HP-60 (24 months warranty) - 1 pc.
2. Membrane tube air diffuser JAGER TD 63/2050 (0.5 m long) - 1 pc.
3. Connector for connecting the hose to the diffuser - 1 pc.
4. Rubber gasket to ensure the tightness of the connection - 1 pc.
5. Stainless steel clamps AISI 16-25 mm. 2 pcs.
6. A 19 mm inner diameter hose is required for the set. The hose is not included in the set price. Purchase the required hose length separately.
    

Technical specifications of the aeration set:

1. Air flow at 1 m depth - 69 l/min
2. Air flow at 1.5 m depth - 60 l/min
3. Air flow at 2 m depth - 50 l/min
4. Air flow at 2.5 m depth - 39 l/min
5. Recommended diffuser immersion depth - 2-2.5 m
6. Maximum diffuser immersion depth - 2.5 m
7. Maximum recommended hose length - 30 m
8. Power of the air pump motor - about 51 W (depending on operating pressure).
9. Noise level - 35 dB
10. Warranty for the air pump 24 months.
     

Installation and commissioning of the aeration set:

1. First, choose a location for the air pump. We recommend placing the pump as close to the water body as possible. This will help avoid greater air flow losses. The pump can operate outdoors, but it must be protected from direct precipitation and extreme cold. Install the pump in a sealed box (metal, plastic, wooden). Insulation of the box is not necessary, but it is essential to leave openings for air to enter inside. If there is a gazebo, sauna, or other structure near the water body, install the pump there. In both cases, ensure a safe and reliable power supply for the pump.
2. Hose. Use a 19 mm inner diameter pressure hose purchased from us or your own (do not use a watering hose). We recommend using a hose no longer than 30 m. Attach one end of the hose to the pump outlet and securely tighten it with the provided clamp. Take the air diffuser and screw the provided nozzle onto the hose. To ensure tightness, use the provided rubber gasket. Attach the other end of the hose to this connection and tighten it with a clamp.
3. Immersion of the air diffuser. We recommend immersing the diffuser as deep as possible (do not exceed the maximum allowable immersion depth). The higher the water column above the diffuser, the better the air bubbles and the oxygen they contain dissolve in the water, leading to mixing of various water layers. The JAGER air diffuser is lighter than water. To submerge it, tie synthetic ropes to both ends of the diffuser and attach weights to their ends (recommended weight 0.5 - 1 kg). Other methods of submerging the diffuser can be found, but this is the simplest and works perfectly. The recommended rope length between the weights and the diffuser is 20-30 cm. Submerge the prepared diffuser with weights into your chosen location in the water body. The weights will rest on the bottom of the body, and the diffuser will rise as much as allowed by the length of the ropes left. This way, the diffuser will operate without disturbing the bottom sediments and will not cloud your water body.
4. Plug the air pump into the electrical network, and the aeration system will start working. If there is no need to aerate around the clock, purchase a timer and set the desired operating mode. The aeration system is designed to operate in both continuous and intermittent modes. Enjoy using it.

More information about the air pump:

More information about the air diffuser: